Quick Codes
This information originally came from Jerry at CMP, but it’s reproduced here because it’s rather useful. Some of these codes are Syspine-only, but 872, 822, 886 should work on all platforms.
Command Codes for Syspine
Code Function
#*IP(47) Gives phone IP address in the display
#*MENU (6368) Shows phone menu in phone display (Adjust
ringing here and much more)
#=Enter
Call History Key takes you back one level
Lift and replace handset to exit phone menu
UP/DOWN arrows to scroll
872# Code to access external paging amplifier
822# Access to auto attendant
886# Access to Voice Mail
8* <slot> # = Retrieve parked call (not documented on help screen)
*08# = DND Toggle
Speaker Phone = alternate exit from Menu
Mute = Clears out digits on some setting screens
Suggestion: Default ‘Hold Recall’ timer appears to be 180 seconds,
but the phone drops the call after 120, so you don’t get any
warning. To correct, change ‘Hold Recall’ under ‘Preferences’ to 30
or 60 seconds. This can also be done from the web interface.
Very good tips, many thanx.
Btw there is any command to broadcast messages to all phones?
Hey there happyhacking. There isn’t a phone-based paging system right now, but I believe it’s being worked on for the future.
Andrew.
Actually there is if you put all the phone in a group. Like group 300 all page Then dial 4*300 it will page all phones on the syspine then to answer push the RP button
How can we configure RP6353i programable button for Park line 1,2,3,4 and with lights indicator